GFI Software

Welcome to the GFI Software community forum! For support please open a ticket from https://support.gfi.com.

Home » GFI User Forums » Kerio Control » Kerio Control HA configuration (Initial config and synchronization.)
Kerio Control HA configuration [message #152512] Wed, 17 August 2022 20:54 Go to next message
devlin is currently offline  devlin
Messages: 11
Registered: March 2019
Hello,
I would like to ask... What I need to configure for HA on Kerio Control? Do I really need to setup on clean new Kerio Control only IP addresses, things in HA menu and everything else will be replicated? Completely all settings? I want to be sure. Thank you...
Re: Kerio Control HA configuration [message #152513 is a reply to message #152512] Wed, 17 August 2022 22:02 Go to previous messageGo to next message
chrisc is currently offline  chrisc
Messages: 102
Registered: January 2022
Hi devlin! What you should end up with after setting up High Availability is a live instance (master) and an exact replica (slave) ready to take over in case the master fails. To make sure you are setting up HA properly, have a look at our knowledge article, Configuring High Availability in Kerio Control.

If you need more specialist info check out the High Availability section of our knowledge base.

If none of the above has the information you need feel free to open a ticket with our expert Technical Support team.


Chris Contorinis
Customer Care Specialist
GFI Software
Re: Kerio Control HA configuration [message #152530 is a reply to message #152513] Fri, 19 August 2022 14:52 Go to previous messageGo to next message
devlin is currently offline  devlin
Messages: 11
Registered: March 2019
Hi, thank you! I only wanted to be sure, that everything I need to setup before HA are network interfaces and the rest will be replicated. Only thing I am thinking about right now is VPN server and site to site Kerio VPN tunel. This is replicated too and should also work in HA without problems, am I right?

Thank you Smile
Re: Kerio Control HA configuration [message #152532 is a reply to message #152513] Fri, 19 August 2022 15:26 Go to previous messageGo to next message
devlin is currently offline  devlin
Messages: 11
Registered: March 2019
I can have the same IP address on the WAN interface, because one of the Kerio Controls is always inactive right?

Thank you.. I have to configure HA on a critical remote firewall next week so I want to be sure with everything.
Re: Kerio Control HA configuration [message #152701 is a reply to message #152532] Sat, 17 September 2022 12:15 Go to previous message
wvmueller is currently offline  wvmueller
Messages: 8
Registered: May 2012
Hi,
dit it work that the Slave Control activate the WAN interface after the Master Control went offline?

We setup an HA-Cluster and the Slave Controls WAN Interface was not activated after the Master went offline. A manual activation of the Wan Interface on the Slave worked, but this is not the sense of HA-Cluster.

Thanks for your reply
Previous Topic: site-to-site pfSense Kerio Control tunnel
Next Topic: Kerio as VPN Client
Goto Forum:
  


Current Time: Sat Nov 26 09:44:21 CET 2022

Total time taken to generate the page: 0.02491 seconds