GFI Software

Welcome to the GFI Software community forum! For support please open a ticket from https://support.gfi.com.

Home » GFI User Forums » GFI FaxMaker » Best practice fax speed rate in Faxmaker
Best practice fax speed rate in Faxmaker [message #148264] Fri, 12 June 2020 15:52 Go to next message
brianh743 is currently offline  brianh743
Messages: 4
Registered: June 2020
Is there a recommended fax rate in GFI that is considered best practice? We are working with our telecom vendor on some phone system issues and one of the things they found is our fax rate is not set the same across the board in our system. The main lines are set to 14400 but some of the dial peers are set to 9600.

Report message to a moderator

Re: Best practice fax speed rate in Faxmaker [message #148271 is a reply to message #148264] Sat, 13 June 2020 22:49 Go to previous messageGo to next message
ian.bugeja is currently offline  ian.bugeja
Messages: 666
Registered: March 2017
Location: Malta
Hi

all lines should use the same rate, but the rate depends on the hardware/software being used.

Are you using SR140?

Regards

Ian Bugeja
GFI Software

Report message to a moderator

Re: Best practice fax speed rate in Faxmaker [message #148278 is a reply to message #148271] Mon, 15 June 2020 13:57 Go to previous messageGo to next message
brianh743 is currently offline  brianh743
Messages: 4
Registered: June 2020
Yes, we are using Brooktrout SR140

Report message to a moderator

Re: Best practice fax speed rate in Faxmaker [message #148295 is a reply to message #148278] Tue, 16 June 2020 11:15 Go to previous messageGo to next message
ian.bugeja is currently offline  ian.bugeja
Messages: 666
Registered: March 2017
Location: Malta
SR140 shoud accept the maximum of 14400, so if the line/hardware supports that you can use that value.

Ian Bugeja
GFI Software

Report message to a moderator

Re: Best practice fax speed rate in Faxmaker [message #148296 is a reply to message #148295] Tue, 16 June 2020 13:54 Go to previous message
brianh743 is currently offline  brianh743
Messages: 4
Registered: June 2020
Thank you for response. That is what we will continue to go with and see if that fixes our issues.

Report message to a moderator

Previous Topic: GFI FaxMaker Attendant Service not startable after clock change
Next Topic: Print or Save Sent efax transmission reports
Goto Forum:
  

[ Syndicate this forum (XML) ] [ RSS ] [ PDF ]

Current Time: Tue May 30 02:47:47 CEST 2023

Total time taken to generate the page: 0.05461 seconds
.:: Contact :: Home :: Acceptable Use Policy ::.

Powered by: FUDforum 3.0.9.
Copyright ©2001-2022 FUDforum Bulletin Board Software