GFI Software Aurea SMB Solutions


Home » GFI User Forums » Kerio Control » Possibility of multiple interfaces with the same VLANid (Creating a properly meshed, HA kerio setup with two switches)
Possibility of multiple interfaces with the same VLANid [message #145765] Mon, 13 May 2019 01:20
TJLeeson is currently offline  TJLeeson
Messages: 1
Registered: May 2019
I'm looking to create a properly meshed HA setup with two NG500s in HA mode. This requires each kerio to have links to two switches in order to avoid Single Point of Failures at any point in the network

For this to work both switches should be able to reach either NG500 independently. This would require either bridging the two physical interfaces on the NG500s and running VLAN subinterfaces off the bridge, or addingfour vlan interfaces to the HA "virtual IP", two on each unit.

Does anyone have any experience of doing this or know if it's possible? Bridging interfaces and running VLAN ints off them is supported in linux but I dont think in the GUI.

Any help is appreciated.
Previous Topic: How install QEMU AGENT on Kerio Control 8.2.2
Next Topic: Unable to get start and end date for Kerio Control Statistics
Goto Forum:
  


Current Time: Mon Jul 22 14:09:50 CEST 2019

Total time taken to generate the page: 0.03317 seconds