GFI Software

Welcome to the GFI Software community forum! For support please open a ticket from https://support.gfi.com.

Home » GFI User Forums » Kerio Control » Kerio control Wan comming from proxy (proxy,wan, port)
Kerio control Wan comming from proxy [message #139576] Fri, 27 April 2018 09:58 Go to next message
lara2005 is currently offline  lara2005
Messages: 2
Registered: November 2016
Location: oran
Hi
i have one interface for wan
this wan is comming from lan proxy with port 8080 and authentification
how to put all information of this in interface wan
and have lan as out to distribuate internet comming from to users

internet ---------------------------- kerio control (proxy transprent) ---------------------LAN
information of proxy
xxx.xxx.xxx.xxx port 8080
authentification
user :xxxxxxxxx
password:xxxxxx

thanks

[Updated on: Fri, 27 April 2018 09:59]

Report message to a moderator

Re: Kerio control Wan comming from proxy [message #148702 is a reply to message #139576] Mon, 21 September 2020 08:13 Go to previous message
Mr.Torture is currently offline  Mr.Torture
Messages: 1
Registered: September 2020
I have the same problem. It is necessary to wrap some of the specific traffic on a separate wan interface that looks into the proxy. Even if I configure the proxy to send traffic without authorization, nothing happens. The rule "trusted - the required address - any - any - allow - nat to the wan interface connected to the proxy" works out - connections to the required interface are visible in the connections of the active host, but there are no connections in the proxy logs. If in the broadcast I specify a specific proxy server ip-address and broadcast port, then in the proxy server logs you can see connections from the Kerio ip-address, but no traffic goes - the client does not open anything.
Previous Topic: Egress priority VLAN
Next Topic: IPS
Goto Forum:
  


Current Time: Sun Sep 25 00:52:14 CEST 2022

Total time taken to generate the page: 0.02083 seconds