GFI Forums: Kerio Connect Multi-Server » Repository Error When installing Puppet Master

Home » OLD forums » Kerio Connect Multi-Server » Repository Error When installing Puppet Master

Show: Today's Messages :: Show Polls :: Message Navigator
E-mail to friend

Repository Error When installing Puppet Master [message #124477]

Fri, 25 September 2015 05:32

ScottOhalloran
Messages: 3
Registered: September 2015

I am trying to install the puppet master but the install always ends with an error message "Could not find a suitable provider for mysql_user
err: Could not find a suitable provider for mysql_database
info"

I have looked through the install log and I keep seeing failure messages referring to galera_mariadb_repo

Attachment: puppet-install-2015-09-25_02-45-14.log
(Size: 143.42KB, Downloaded 917 times)

Report message to a moderator

Re: Repository Error When installing Puppet Master [message #124501 is a reply to message #124477]

Fri, 25 September 2015 18:55

Bud Durland
Messages: 586
Registered: December 2013
Location: Plattsburgh, NY

Yeah, I got something similar trying to set up the KC-MS 9.0 beta. Screen shot attached. This time I was careful to make sure there was a DHCP reservation defined for the VM's network card before I started the VM. It had an IP address with unfettered access to anywhere on the internet.

This product is SO not ready for prime time.

Attachment: KCMS-Fail.PNG
(Size: 263.08KB, Downloaded 754 times)

Report message to a moderator

Re: Repository Error When installing Puppet Master [message #124505 is a reply to message #124501]

Fri, 25 September 2015 21:28

ScottOhalloran
Messages: 3
Registered: September 2015

Thank you Bud. I just tried doing that and wound up with the same result. I have also tried upping the memory and number of processors. It's very frustrating. There just aren't any FAQs or ways to know if you need to change any configuration or open firewall ports.

Report message to a moderator

Re: Repository Error When installing Puppet Master [message #124514 is a reply to message #124477]

Mon, 28 September 2015 06:45

ScottOhalloran
Messages: 3
Registered: September 2015

I finally managed to get all the servers installed without errors. I had to install them on a VMWare host I have in Germany and migrate them to our office in California. Once again, an installation FAQ that says which ports need to be open to allow installation would be nice.

Report message to a moderator

Previous Topic:	problem with SMTP service: 451 4.3.2 Internal server error
Next Topic:	Multi-Server Error When Provisioning First Backend

Goto Forum:

-=] Back to Top [=-

[ Syndicate this forum (XML) ] [

] [

]

Current Time: Fri Jun 09 07:48:25 CEST 2023

Total time taken to generate the page: 0.01912 seconds