GFI Software

Welcome to the GFI Software community forum! For support please open a ticket from https://support.gfi.com.

Home » GFI User Forums » Kerio Control » How to bind DHCP service only to one interface?
How to bind DHCP service only to one interface? [message #113355] Mon, 12 May 2014 20:41 Go to next message
maa1 is currently offline  maa1
Messages: 90
Registered: April 2005
I have Kerio Control 8.3 with two internal interfaces.
How to bind DHCP service only to one interface?
Re: How to bind DHCP service only to one interface? [message #113367 is a reply to message #113355] Tue, 13 May 2014 05:59 Go to previous messageGo to next message
mlee (Kerio)
Messages: 211
Registered: October 2012
Location: Sydney
May I ask the purpose of doing it?

If you are after disabling the scope, under DHCP there are checkboxes next to the scope, uncheck to disable the scope.


PTSD. BP. OCD. ASPD. BPD. Certified.
Re: How to bind DHCP service only to one interface? [message #113377 is a reply to message #113355] Tue, 13 May 2014 10:32 Go to previous messageGo to next message
maa1 is currently offline  maa1
Messages: 90
Registered: April 2005
May I ask the purpose of doing it?
I need to DHCP work only in the network connected to a interface #2.

under DHCP there are checkboxes next to the scope, uncheck to disable the scope.
it unbind DHCP service from other interfaces?
Re: How to bind DHCP service only to one interface? [message #113384 is a reply to message #113377] Tue, 13 May 2014 13:26 Go to previous message
sappa is currently offline  sappa
Messages: 15
Registered: June 2006
This interest me too
I have 5 network cards and 27 ip adresses on it

and dhcp run on every one ipadress Sad
Previous Topic: statistic page cause the whole Kerio control to restart
Next Topic: Help with metric
Goto Forum:
  


Current Time: Fri Jun 09 23:03:34 CEST 2023

Total time taken to generate the page: 0.02003 seconds