GFI Software

Welcome to the GFI Software community forum! For support please open a ticket from https://support.gfi.com.

Home » GFI User Forums » Kerio Connect » How to tell if 2fa is enabled for users
How to tell if 2fa is enabled for users [message #151384] Mon, 04 April 2022 21:30 Go to next message
ryana is currently offline  ryana
Messages: 8
Registered: November 2019
Is there a way in Kerio Admin to tell if 2fa is enabled for specific users? We are going through all users and having them enable 2fa. But we have no way by looking at the users list if 2fa is actually enabled. If there is not a way, this would be a really helpful feature.
Re: How to tell if 2fa is enabled for users [message #151385 is a reply to message #151384] Tue, 05 April 2022 06:03 Go to previous messageGo to next message
Nick.Geary is currently offline  Nick.Geary
Messages: 73
Registered: January 2021
I would recommend opening a support ticket with us.. Detail that may not be showed in the GUI, are often logged. And Tech support would be in the best position to assist in this.

Nick Geary
GFI Software
Re: How to tell if 2fa is enabled for users [message #151457 is a reply to message #151384] Fri, 15 April 2022 16:37 Go to previous messageGo to next message
Jason1234 is currently offline  Jason1234
Messages: 20
Registered: April 2010
We too have this issue. I enabled Debug logging for user authentication and run a grep on the debug log to capture who has it set up. Of course this would only work prior to deployment. grep -RiI ' 2FA Start Setup successful for use' /kerio/store/logs/
Re: How to tell if 2fa is enabled for users [message #153411 is a reply to message #151457] Sun, 25 December 2022 17:19 Go to previous messageGo to next message
sulinelanie is currently offline  sulinelanie
Messages: 3
Registered: December 2022
Hello,

If two-factor authentication (2FA) is enabled for users, they will be prompted to enter an additional piece of information after they have entered their username and password. This additional piece of information typically includes an authentication code sent to the user's mobile device or an authentication code generated by a security key. If a user is not prompted to enter an additional authentication code, then 2FA is not enabled for that user.

[Updated on: Fri, 06 January 2023 15:40] by Moderator

Report message to a moderator

Re: How to tell if 2fa is enabled for users [message #153508 is a reply to message #151384] Tue, 10 January 2023 10:59 Go to previous message
Corsa600
Messages: 13
Registered: May 2007
Location: Sweden
Did You get an answer from tech support that you can share?

ryana wrote on Mon, 04 April 2022 21:30
Is there a way in Kerio Admin to tell if 2fa is enabled for specific users? We are going through all users and having them enable 2fa. But we have no way by looking at the users list if 2fa is actually enabled. If there is not a way, this would be a really helpful feature.
Previous Topic: Kerio Outlook Connector 10.0 - "unexpected error" message"
Next Topic: nach Platten Crash restore Fehler
Goto Forum:
  


Current Time: Thu Feb 09 13:32:41 CET 2023

Total time taken to generate the page: 0.02675 seconds