GFI Software

Welcome to the GFI Software community forum! For support please open a ticket from https://support.gfi.com.

Home » GFI User Forums » Kerio Connect » Network interface configuration
Network interface configuration [message #110197] Wed, 29 January 2014 10:46 Go to next message
philipp_hauser is currently offline  philipp_hauser
Messages: 23
Registered: January 2014
Hi there,

i'm currently setting up a kerio connect mailserver on a SuSe system with 2 network interfaces.

Interface eth0 should be used to communicate with the clients in the internal network.
Interface eth1 should be used to communicate with the external mail provider (strato).

Is it possible to configure the kerio mailserver to use interface eth0 for the internal communication (imap) and interface eth1 for the external communication (pop3)
Re: Network interface configuration [message #110200 is a reply to message #110197] Wed, 29 January 2014 11:25 Go to previous message
Pavel Dobry (Kerio) is currently offline  Pavel Dobry (Kerio)
Messages: 2057
Registered: October 2003
Location: Czech Republic
Kerio Connect uses network interfaces as configured in network routing table. Ie. for local addresses it uses interface with local IP address, for accessing the Internet it uses interface with default gateway. There is no setting required. Operating system do it automatically.

Previous Topic: Resource Free/Busy information
Next Topic: Sophos issues - any other solutions?
Goto Forum:
  


Current Time: Mon May 29 20:13:00 CEST 2023

Total time taken to generate the page: 0.05310 seconds