GFI Software Aurea SMB Solutions


Home » GFI User Forums » Kerio Control » VPN push to client routing
VPN push to client routing [message #144374] Fri, 02 November 2018 20:23 Go to next message
MSH is currently offline  MSH
Messages: 15
Registered: August 2016
Location: IR
Hi

Is there any way to install VPN so that when client connect to server then server could access the network of client(a reverse scenario as usual VPNs do) something like openvpn or push routing to client.

thanks
Re: VPN push to client routing [message #144382 is a reply to message #144374] Sun, 04 November 2018 15:04 Go to previous messageGo to next message
billybob is currently offline  billybob
Messages: 15
Registered: October 2018
Your best bet probably would be site to site. Push route as far as I know is for pushing route to the clients not the other way around. Pretty similar to the toggle switch for kerio vpn "VPN clients access internet through vpn" which pushes the route to the client.

Let us know if you figure this out.
Re: VPN push to client routing [message #144411 is a reply to message #144374] Thu, 08 November 2018 21:22 Go to previous message
MSH is currently offline  MSH
Messages: 15
Registered: August 2016
Location: IR
Hi
Thanks for answering but site to site is not the purpose . i want to use kerio vpn client. why because 1- I need to connect to 1 static IP 2- from the place that i want to connect is a NAT and static IP is not possible only VPN Client is possible so i want to use kerio vpn client from the NAT place and then connect to server then from the server side Have a IP address range of client side

BR
Previous Topic: TLS Certificate Untrusted
Next Topic: Control Registration failed via key
Goto Forum:
  


Current Time: Tue Jan 22 00:39:33 CET 2019

Total time taken to generate the page: 0.01764 seconds